HOW DOES IT WORK?
The X-8CT wash area is approx. 6750mm wide and 6000mm deep
and comprises eight modular base sections 1500mm x 3000mm and
a central solids collection channel. The wash area is accessible via two
galvanised anti slip ramps as standard. To reduce the risk of overspray
the X-8 has 2200mm high walls on three sides. More ramps can be
ordered as an option.
and comprises eight modular base sections 1500mm x 3000mm and
a central solids collection channel. The wash area is accessible via two
galvanised anti slip ramps as standard. To reduce the risk of overspray
the X-8 has 2200mm high walls on three sides. More ramps can be
ordered as an option.
The washbay floor pan directs dirty water and any solids towards the
centre of the wash area and into a solids collection tank. The solids
collection tank is wide enough to allow a small excavator to remove
any debris from the system. The dirty water then filters through towards
an outlet. At the outlet end of the collection tank is a float switch.
When the water reaches a specified level the float switch activates a
diaphragm pump housed in the Filtration Tank. This pump then sucks
the liquid out of the solids collection tank into the Filtration Tank.
The Filtration Tank then through the use of a number of filters removes
the remaining contaminants and lightly chlorinates the liquid leaving
the clean water ready to be reused in the washbay. All the filters are
easily removed and replaced to ensure continuity of service.
When the end user operates their pressure washer the booster pump
housed within the filtration tank activates to supply the pressure washer
with water as required.
Easy to assemble
Easy to disassemble
Easy to remove
